***1500 fitment only, Heavy Duty fitment is currently not supported***

Just because you have a lot of gear, doesn’t mean you have to have a lot of mess. While standard storage might not cut it, the BuiltRight Industries Bedside Rack System can. Using the same factory mounting points, the rack system installs to keep your gear organized, easily accessible and secure. They work with all MOLLE/PALS accessories in addition to universal slots for all kinds of storage possibilities. Proudly made in USA with a Lifetime Warranty.

Engineering

NOTE: The front panel cannot be used unless you also have a mounted.

In the 2019 GMC/Chevrolet lineup, each truck bed is equipped with three oval shaped holes in the bedside. Used along with the tie down loops near the front and rear, the Silverado and Sierra is very well equipped to support a full length MOLLE panel system. The BuiltRight Modular Bedside Rack System installs using these factory mounting points, without the need for modification to the vehicle. The panels provide MOLLE-compatible features for the use of MOLLE/PALS accessories in addition to universal slots for an infinite number of possibilities.

The Silverado and Sierra panels can be used as a 4pc kit, of course, but the rear panels can also be used on their own, without the front panels. This allows users to setup their truck as needed and add to their system if their gear mounting needs change. The front panels cannot be used on their own, as they attach to the rear panels for support. 

• Store items that need to be easily accessible and organized
• Keep tools, straps, shackles, etc from rolling around in the bed of your truck
• Easily configured depending on intended use
• Made in USA. Lifetime Warranty.

Fitment:

• 2019 Chevrolet Silverado 5'7" Bed and 6ft4in Bed (select size)
• 2019 GMC Sierra 5'7" Bed and 6ft4in (select size)
• Not compatible with Carbon Pro beds

Kit Includes: 

• 1x Front panel (use on either side)
• 1x Hardware kit w/ support brackets

Install

Installation is quick and easy. Remove the plastic covers plugging the oval shaped holes in the bed. Prepare the support brackets and tie down blocks and install them, snug but not fully tight. Lift the rear panel into place, ensuring that holes on both brackets line-up with the slots in the panel. Now tighten mounting brackets and then lift panel back into place, installing the eight included button head screws. Tighten all hardware and you're done. Expect to spend 15-20min per side.

Kit includes all hardware necessary for installation.